Rockwell Automation 20P PowerFlex DC Drive - Frame B Bimetal Thermostat - Manual (Page 12)

12 PowerFlex® DC Drive - Frame B Bimetal Thermostat
4. Remove the screw and washer that secures the wire to the bus bar and
the bolt and washer that secures the U phase bus bar to the SCR module
and remove the bus bar.
5. Remove the bolt and washers that secure the D terminal bus bar to the
terminal isolation bar.
Continue with Remove the Bimetal Thermostat on page 14 .
5. Remove bolt and
washer from isolation bar
4. Remove bolt,
screw and
washers
4. Remove bus bar