Rockwell Automation 20D-P2-ENCO PowerFlex 700S Drive Phase II Control Second Encoder Option Card User Manual
Page 8
8
Second Encoder Option Card for PowerFlex® 700S Drives with Phase II Control
Step 9: Installing the
Stacker Connector and
Second Encoder Option
Card
Important: Do not use a screwdriver to pry the P1 terminal plug from the
circuit board. This may damage the plug.
!
ATTENTION: If you fail to remove the Two-Pin Jumper before
installing the Second Encoder Option Card, you may damage the
main control board. Make sure you remove the jumper before
installing the Stacker Connector.
Task
Description
Remove the terminal block P1 from the Second Encoder Option Card
It is much easier to remove before the card is installed
Plug the long pins of the Stacker connector into the Second Encoder
Option Card.
The end with the long pins must plug into the Option Card
Plug the Second Encoder Option Card and Stacker connector onto the
mating connector of the main control board.
The end with the short pins must plug into the main control board.
Install and tighten three M3 screws (7-10 lb.- in.)
A
B
C
D
=
The end with the long pins
must plug into the Option
Card.
B
C
D