Rockwell Automation 20P PowerFlex DC Drive - Frame C AC Line Snubber Board and High Wattage Resistors - Manual (Page 14)

14 PowerFlex® DC Drive - Frame C AC Line Snubber Board and High Wattage Resistors
Step 6: Install the New AC
Line Snubber Board and
Resistors Install the AC Line Snubber boards and Resistors in reverse order of
removal and detailed in Step 5:
Remove the Existing AC Line Snubber
Circuit Board and Resistors on page 12 .
•
Apply thermal grease to the bottom of the resistors before securing them
to the heatsink.
Step 7: Install the Pulse
Transformer and Field
Snubber Circuit Boards Install the Pulse Transformer and Field Snubber boards in reverse order of
removal and detailed in Step 4:
Remove the Pulse Transformer and Field
Snubber Circuit Boards on page 8 .
Step 8: Install the EMI
Shield and Control Board Install the EMI Shield and Control board in reverse order of removal as
detailed in Step 3:
Move the EMI Shield and Control Board on page 5 .
!
ATTENTION: Thermal grease must be applied to the bottom
of the resistors before securing them to the heatsink or damage to
the drive may occur.
!
ATTENTION: Each gate lead cable must be connected to the
exact connector from which it was removed on the Pulse
Transformer circuit board or damage to the drive may occur.