Rockwell Automation SK-L1-CAP2-D1250 Filter Capacitor Kit SK-L1-CAP2-D1250 for PowerFlex 700L Fr. 3B 480V AC Drives - Manual (Page 3)

Rockwell Automation Publication 20L-IN016A-EN-P - February 2012 3
Filter Capacitor Replacement Kit SK-L1-CAP2-D1250 for PowerFlex 700L Frame 3B 480V AC Drives
Tools That You Need • Properly-rated, isolated multi-meter (DMM) to measure the AC input
and DC filter capacitor voltages (working voltage specifications should be
1000V)
• 3/8-inch drive ratchet
• 3/8-inch drive 10 mm deep well socket
• 3/8-inch drive 3/4-inch deep well socket
• 3/8-inch drive 3/8-inch socket or 3/8-inch box wrench
• Torque wrench capable of 50 lb•in (5.6 N•m)
• Torque wrench capable of 35 lb•ft (47.5 N•m)
• 10 mm box wrench
• T25 Torx bit
• #1 Phillips screwdriver
• Small wire cutter
• Lockout/Tagout kit
• Work gloves
• Nylon wire ties
• Arc Flash Gear
You may also need a box or container to hold loose hardware.
Precheck
Drives built prior to May 2008 had older style SPDs mounted on the filter
capacitor bank assemblies. If a surge trap style SPD is not installed in the drive, it
is necessary to order and install a surge trap upgrade kit, Catalog Number 21T-
385253-A01 to insure there is proper transient protection for the equipment.
IMPORTANT Inspect the surge trap (SPD) in the drive and note whether the visual
inspection tab has been activated. This indicates internal damage and the need
for replacement. For the location of the surge trap, see
Figure 7 on page 11 .
Visual Inspection Tab Detail Surge Trap (SPD) in Drive