Rockwell Automation 592- E300 Overload Relay User Manual - Manual (Page 301)

Rockwell Automation Publication 193-UM015B-EN-P - June 2014 301
EtherNet/IP Communications Chapter 8
13. To control the output relays or remote reset the E300 Electronic Overload
Relay navigate to the output tags created by the Add-On Profile.
Logix Configuration with a Generic Profile
An existing project can be used or a new project can be created to configure
EtherNet/IP I/O Messaging. After the Logix controller has been configured, the
E300 Electronic Overload Relay EtherNet/IP Communication Module must be
added to the I/O configuration. Follow these steps when using a Generic Profile.
1. Right-click on the EtherNet/IP scanner within the I/O Configuration
folder, then select New Module to open the Select Module Type window.