Rockwell Automation 440F Safedge Pressure Sensitive Safety Edge System User Manual
Page 7
3.0 INSTALLATION OF THE SAFEDGE SYSTEM
ONLY USE 440F-A0020 CYANOACRYLATE.
The cyanoacrylate adhesive ensuring a lasting sealing and high protection to IP65.
3.1 INSTALLATION OF “C” RAIL
"C" RAIL
CABLE CONNECTOR
CLOSING CAP
TO CONTROL UNIT
OR NEXT PIECE
OF PROFILE
CONNECTOR
WITH RESISTOR
6
21
6.2.4 Repair
Prior to working on a Safedge system or machine control system, isolate the power source to the
machine and Safedge system. Observe electrical safety precautions.
User repairs are limited to replacement with new Safedge system parts. In the event of any problems,
the units should be returned to the supplier.
Any repairs to the connecting wires should be made using heat shrink butt splice connectors.
After replacing any parts the inspection and test shown at 6.2.2 & 6.2.3, must be carried out with
special attention given to those parts replaced.
TAMPERING WITH COMPONENT PARTS WILL INVALIDATE WARRANTY.
WARRANTY INVALID IF QUALITY SEAL IS BROKEN ON THE DIN RAIL (440F-C251D) CONTROL
UNIT
WARNING
After maintenance or repair operations it is important that all fastenings, cable protection etc, are
correctly refitted. Failure to do this or the use of non approved parts may result in the Safedge system
failing to achieve its specified performance.