Rockwell Automation 445L Floor Mounting Column and Cantilever User Manual - Manual (Page 6)

Floor Mounting Stand and Cantilever User Manual
4
Original instructions
445L-AMSTDMUT Cantilever—Assembly Steps
Step 1: Supplied parts
Optional parts for muting—not supplied
8 RightSight retroreflective sensor 42EF-P2MPB-Y4
7 RightSight swivel/tilt bracket 60-2649
- 4-pin straight DC micro QD patchcord 889D-F4ABPM-X (X is length in meters) (not shown)
5 Large reflector 92-39 (76 mm (3 in.) diameter) or small reflector 92-47 (32 mm (1.25 in.) diameter)
Step 2: Assemble 500 mm cantilever post
Pos Qty Description
1 1 pc. Aluminum profile 60 x 60 x 500 mm (2.4 x 2.4 x 19.7 in.)
1 pc. Black end cap 60 x 60
2 1 pc. Aluminum cover profiles for hiding cables (300 mm
(11.8 in.))
3 To attach cantilever post to the floor stand post
4 pcs. Stainless steel universal fastening set #6 (item no. 0044174)
4 1 pc. Mounting kit for reflector (reflector not supplied)
1 pc. bracket 80 x 40 x 20 Zn (Item No. 0047463)
Bracket mounting hardware:
1 pc. washer (flat) M6 x 12 mm (0.47 in.) (zinc)
1 pc. hexagon socket head cap screw DIN 912 M6 x 16 mm
(0.63 in.)
1 pc. T-slot nut 6 steel M6, zinc plated
Reflector mounting hardware
1 pc. hexagon socket head cap screw DIN 912 M5 x 30 mm
(1.18 in.)
1 pc. washer (flat) M5 x 10 mm (0.39 in.) (zinc)
1 pc. hexagon nut DIN 934 M5 (zinc)
6 RightSight bracket 60-2649 mounting hardware
2 pcs. Hexagon socket head cap screw DIN 912 M6 x 14 mm
(0.55 in.)
2 pcs. T-slot nut 6 steel M6, zinc plated
Slide the four universal fastening sets in each slot on the left or the right side
of floor mounting stand.
Place the lower universal fastening sets at the desired height. Make sure that
the bezels of the lower universal fastening sets are on the upside.
Place the upper universal fastening sets about 100 mm higher than the
lower ones. Make sure that the upper bezels of the universal fastening sets
are on the underside.
2
4
5
6
8
7
3
1