Braun NL Series - Manual (Page 47)

Page 45
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Correct, replace defective parts and/or relubri-
cate.
Resecure, replace or correct as needed. See
Platform Angle Instructions and Microswitch
Adjustment Instructions.
Maintenance and Lubrication Schedule
Perform all procedures listed in previous section also
Platform pivot pin bearings (2)
Platform fold axles (2)
Inner roll stop lever bearings (2)
Inner roll stop lever slot (2)
Rotating pivot slide arm pivot pins (2)
Parallel arm pivot bearings (16)
Handrail pivot pin bearings (4)
Hydraulic cylinder bushings (8)
Inspect Lift-Tite ™ latch rollers for wear or damage,
positive securement and proper operation (2)
Inspect inner roll stop for:
• Wear or damage
• Proper operation. Roll stop should just rest on
top surface of the base plate.
• Positive securement (both ends)
1500
Cycles
continued