Rockwell Automation 284A ArmorStart with ArmorPoint Backplane - Getting Started - Manual (Page 28)

28
Publication 284A-QS001C-EN-P - July 2006
Table 5 Basic Program Group for Sensorless Vector Control
➊ Stop drive before changing this parameter.
➋ See Important below:
➌ Available with the A10 factory installed option.
Parameter
Number
Parameter
Description
Display/
Options
Min./
Max.
Defaults
Settings
131 ➊ Motor NP Volts 1 VAC
20/Drive Rated
Volts
Based on
Driving
Rating
132 ➊ Motor NP Hz 1 Hz 15/400 Hz 60 Hz
133
Motor OL
Current
0.1 A
0.0/(Drive Rated
Amps x 2)
Based on
Driving
Rating
134 Minimum Freq. 0.1 Hz 0.0/400 Hz 0.0 Hz
135 ➊
Maximum
Freq.
0.1 Hz 0.0/400 Hz 60 Hz
136 ➊ Start Source
0 = Keypad ➋
1 = 3-Wire ➋
2 = 2-Wire
3 = 2-W Lvl Sens
4 = 2-W Hi Speed
5 = Comm Port
0/5 5
137 Stop Mode
0 = Ramp, CF
1 = Coast, CF
2 = DC Brake, CF
3 = DCBrkAuto, CF
4 = Ramp
5 = Coast
6 = DC Brake
7 = DC BrakeAuto
8 = Ramp + EM B, CF
9 = Ramp + EM Brk
0/9 9
138
Speed
Reference
0 = Drive Pot ➋
1 = InternalFreq
2 = 0…10V Input ➋➌
3 = 4…20 mA Input ➋
4 = Preset Freq
5 = Comm Port
6 = Stp Logic
7 = Anlg in Mult ➋
0/7 5
139 Accel Time 1 0.1 Secs 0.0/600.0 Secs 10.0 Secs
140 Decel Time 1 0.1 Secs 0.0/600.0 Secs 10.0 Secs
141 ➊
Reset to
Default
0 = Ready/Idle
1 = FactoryRset
0/1 0
IMPORTANT
These drive parameters options will cause the
Bulletin 284 ArmorStart Distributed Motor Controller to
become disabled.