Rockwell Automation 1398-DDM-xxx ULTRA 100 Series Drives Installation Manual User Manual
Page 36
Advertising
Publication 1398-5.2 – PDF 1997
2-6
Unpacking, Inspecting and Storing
13. Select
R
ead Drive Parameters
from the Communications menu
in ULTRA Master.
14. Select
OK
in the Drive Select dialog box. A dialog box indicating
that the PC is reading drive parameters should appear.
If this dialog box does not appear, a message appears that advises
you to check the COM settings and the communication cable. If
necessary, refer to “Troubleshooting” on page 11-3 for
instructions on how to perform these checks.
Advertising