Rockwell Automation 1394 INSTL.INSTRU.1394 TURBO FIRMW - Manual (Page 11)

Upgrading your 1394 GMC Turbo Firmware 11
Publication 1394–6.3 – November 1997
10.
If the Image Received
OK. Proceed with
Reprogram? (Y|N)
message:
Do this:
Appears
1. T ype Y and then press Enter to start
the image transfer from the 1394
system memory (DRAM) to the flash
chip.
ATTENTION: Interrupting this
process can cause serious damage
to the firmware inside your 1394
GMC Turbo.
The following messages appear:
System will inform you
with a message when
completed.
Flash ID OK, Beginning
erase process..
Flash SECTOR=0 ERASE OK
Flash SECTOR=1 ERASE OK
* * *
* * *
Flash SECTOR=7 ERASE OK
Flash ERASE OK, Beginning
program process..
DO NOT INTERRUPT or
system may become
inoperable!
FLASH UPDATE COMPLETED!
RESET the controller for
the Firmware change to
take effect.
2. Go to step 11.
Does not appear 1
1. Press the Control Reset button on
the 1394.
2. Go back to Completing the
Download Using HyperTerminal.
1 Depending on your computer hardware, you may only receive part of the echoed
messages. If any portion of the
Image Received OK. Proceed
with Reprogram? (Y|N) message appears, Type Y, press enter and
proceed with the Appears instructions.