Rockwell Automation 1394 INSTL.INSTRU.1394 TURBO FIRMW - Manual (Page 9)

Upgrading your 1394 GMC Turbo Firmware 9
Publication 1394–6.3 – November 1997
15.Press Enter after each of the following messages:
Edit RIO Config? NO
Run App Program on Power–up? NO
Machine setup Menu? NO
Hookup Diagnostic Menu? NO
Servo Setup Menu? NO
Save Setups to App Module? No
The following command prompts appear:
*
>
16.Go to Completing the Download using HyperTerminal
Completing the Download using HyperTerminal
To download the firmware code into the DRAM memory on the
1394 GMC Turbo:
1. Insert the firmware diskette included with the kit into your disk
drive.
2. At the HyperTerminal command prompt, type bz and then press
Enter. The following messages appear:
Update flash Memory Utility
Enter Password (not echoed):
3. Type obrut and then press Enter. You will not be able to see the
letters you are typing. The following message appears:
Do you wish to download new operating system
F/W ? (Y | N)
4. Type Y. The following message appears:
OK to proceed w/ Download (Y | N).
5. Type Y. The following message appears:
Disabling all interfaces except PORT A
Awaiting download of code....