Rockwell Automation 1756-EN2T ControlLogix EtherNet/IP Module Installation Instructions - Manual (Page 12)

12 ControlLogix EtherNet/IP Module
Rockwell Automation Publication 1756-IN603C-EN-P - April 2010
Make sure that the module backplane connector properly connects to
the chassis backplane.
Connect the Module to the EtherNet/IP Network
1. Be sure that power is removed or the area is nonhazardous before
proceeding.
2. Attach the RJ45 connector to the Ethernet port on the bottom of the
module as shown.
TIP
The module is properly installed when it is flush with the power supply or
other installed modules.
WARNING: If you connect or disconnect the communication cable
with power applied to this module or any device on the network,
an electrical arc can occur. This could cause an explosion in
hazardous location installations.