Rockwell Automation 1746-BTM Barrel Temperature Control Module User Manual - Manual (Page 17)

1 Publication 1746-UM010B-EN-P - April 2001
Chapter
2
Installing and Wiring
This document gives you information about:
•
avoiding electrostatic damage
•
compliance with European Union directive
•
determining the module’s chassis power requirement
•
planning for sufficient enclosure depth
•
choosing a module slot in a local I/O chassis
•
installing the module
•
wiring the module
Avoiding Electrostatic
Damage Electrostatic discharge can damage semiconductor devices inside this
module if you touch backplane connector pins. Guard against
electrostatic damage by observing the following precautions:
•
Touch a grounded object to rid yourself of charge before
handling.
•
Wear an approved wrist strap when handling the module.
•
Handle the module from the front, away from the backplane
connector.
•
Do not touch backplane connector pins.
ATTENTION
!
Electrostatic discharge can degrade performance or
cause permanent damage. Handle the module as
stated below.