Rockwell Automation 1792D-8BVT8CD ArmorBlock MaXum 8 Input/8 Output Module with Complete Diagnostics - Manual (Page 4)

4 ArmorBlock MaXum 8 Input / 8 Output Module Series B
Publication 1792D-IN020B-EN-P - September 2000
The module is equipped with AutoBaud detect. AutoBaud lets the module
read the settings already in use on your DeviceNet network and automatically
adjusts to follow those settings.
Install the Module
This module mounts to the following cable bases:
• 1792D-CBFM for KwikLink™ flat media installation
• 1792D-CB12 for 12mm drop cable installation
• 1792D-CB18P for round media DeviceNet and output power
• or other optional cable base assembly.
To install the module:
1. Position the module over the mounted cable base. Align the three
captive screws in the module with the accepting receptacles in the
base.
2. Tighten the screws with a torque of 8 inch-pounds to secure the
module to the base.
IMPORTANT
The cable base should already be installed. See
publication 1792D-IN009B-EN-P to install the cable
base.
IMPORTANT
Proper alignment of the screws is necessary to complete
the connections between the module contacts and the
cable contacts.