Rockwell Automation 1792D2B0LP ArmorBlock LP2 2 Sinking Input Module - Manual (Page 2)

2 ArmorBlock LP2 2 Sinking Input Module
Publication 1792D-5.43 - July 1999
European Communities (EC) Directive Compliance
If this product has the CE mark it is approved for installation within the
European Union and EEA regions. It has been designed and tested to meet
the following directives.
EMC Directive
This product is tested to meet the Council Directive 89/336/EC
Electromagnetic Compatibility (EMC) by applying the following
standards, in whole or in part, documented in a technical construction file:
• EN 50081-2 EMC — Generic Emission Standard, Part 2 — Industrial
Environment
• EN 50082-2 EMC — Generic Immunity Standard, Part 2 — Industrial
Environment
This product is intended for use in an industrial environment.
Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low Voltage,
by applying the safety requirements of EN 61131-2 Programmable
Controllers, Part 2 - Equipment Requirements and Tests.
For specific information required by EN 61131-2, see the appropriate
sections in this publication, as well as the Allen-Bradley publication
Industrial Automation Wiring and Grounding Guidelines For Noise
Immunity, publication 1770-4.1.
This equipment is classified as open equipment and must be mounted in an
enclosure during operation to provide safety protection.
Install Your ArmorBlock LP2 I/O Module
To install the module you must:
• Set the node address and baud rate.
• Mount the module.
• Connect the input cord sets to the LP2 module.
• Communicate with your ArmorBlock LP2 module.
Each of these steps is discussed in detail in the following procedures.