Rockwell Automation 1790D-XXXX DeviceNet 32 Point Digital Base Terminal Block CompactBlock LDX I/O Series B - Manual (Page 8)

8 DeviceNet 32 Point Digital Base Terminal Block CompactBlock LDX I/O
Publication 1790-IN014A-EN-P - March 2008
Mount on DIN Rail
For DIN-rail mounting, use these steps.
1. Hook the top slot of the base block over the DIN rail.
2. Pull down on the locking lever while pressing the base block
against the rail.
3. Push up on the locking lever to secure the base block to the
rail when the base block is flush against the rail.
Mount the Optional Expansion Block
To mount the optional expansion block, use these steps.
1. Mount the expansion block by connecting it to a
previously-installed CompactBlock LDX I/O base or expansion
block.
2. Beginning with the base block, mount your expansion block
either horizontally or vertically.
•
To mount horizontally (left to right), add an expansion
block in an end-to-end configuration.
44253
Locking Lever
44372
Right Side Up Right Side Up Right Side Up Right Side Up