Rockwell Automation 1734-8CFG POINT I/O Module with 8 Configurable 24V DC Points IN - Manual (Page 10)

10 POINT I/O Module with 8 Configurable 24V DC Points
Publication 1734-IN038A-EN-P - October 2008
Install the Removable Terminal Block
Read this for information if a removable terminal block (RTB) is supplied
with your wiring base assembly, noting that 1734-TOP and 1734-TOPS bases
do not have an RTB.
To insert the RTB, proceed as follows. Note that if you pull up on the RTB
handle to remove the RTB, you can remove and replace the mounting base as
necessary without removing any of the wiring.
1. Insert the end opposite the handle into the base unit, noting that this
end has a curved section that engages with the wiring base.
2. Rotate the terminal block into the wiring base until it locks itself into
place.
3. If an I/O module is installed, snap the RTB handle into place on the
module.