Rockwell Automation 1734-8CFG POINT I/O Module with 8 Configurable 24V DC Points IN - Manual (Page 7)

POINT I/O Module with 8 Configurable 24V DC Points 7
Publication 1734-IN038A-EN-P - October 2008
Install the Mounting Base
Follow these steps to install the mounting base on the DIN rail.
1. Position the mounting base vertically above the installed units, for
example, adapter, power supply, or existing module.
2. Slide the mounting base down so that the interlocking side pieces
engage the adjacent module or adapter.
3. Press firmly to seat the mounting base on the DIN rail until the
mounting base snaps into place.
4. To remove the mounting base from the DIN rail, remove the module,
and use a small bladed screwdriver to rotate the base locking screw to
a vertical position. This releases the locking mechanism. Then lift
straight up to remove.
44714
1734-TOP or
1734-TOPS
One-piece
Terminal Base
with Screw or
Spring Clamp
Insertable
I/O Module
Slide-in
Writable Label
Handle
Module Locking
Mechanism
Interlocking
Side Pieces
DIN Rail Locking
Screw (orange)
Module Wiring
Diagram
Mechanical
Keying (orange)