Rockwell Automation 1747-ASB Remote I/O Adapter - Manual (Page 29)

1 Publication 1747-UM006B-EN-P - June 2003
Chapter
2
Quick Start for Experienced Users
This chapter helps you to get started using the 1747-ASB module. We
base the procedures here on the assumption that you have an
understanding of PLC and SLC 500 products, as well as the RIO link.
You should understand electronic process control and be able to
interpret the ladder logic instructions required to generate the
electronic signals that control your application.
Because it is a start-up guide for experienced users, this chapter does
not contain detailed explanations about the procedures listed. It does,
however, reference other chapters in this book where you can get
more detailed information.
If you have any questions, or are unfamiliar with the terms used or
concepts presented in the procedural steps, always read the
referenced chapters before trying to apply the information.
This chapter:
•
tells you what tools and equipment you need
•
lists preliminary considerations
•
describes when to address and configure the module
•
explains how to install and wire the module
•
discusses system power-up procedures
Have the following tools and equipment ready:
Required Tools and
Equipment
•
medium blade screwdriver
•
(2) 1/2 watt terminating resistors (See chapter 5, Installation
and Wiring, for correct size.)
•
an adequate length of RIO communication cable (Belden
9463) for your specific application (See Chapter 5 Installation
and Wiring, for maximum cable distances.)