Rockwell Automation 1751-SLBP SynchLink Bypass Switch Block Installation Instructions - Manual (Page 5)

SynchLink Bypass Switch Block 5
Publication 1751-IN003B-EN-P - September 2001
Prevent Electrostatic Discharge
Installing the Bypass Switch Block
To install the switch block on the DIN rail:
1. Position the switch block on the 35×7.5mm DIN rail (Allen-Bradley catalog
number 199-DRI) at a 30° angle.
ATTENTION
!
This equipment is sensitive to electrostatic discharge, which
can cause internal damage and affect normal operation.
Follow these guidelines when you handle this equipment:
•
Touch a grounded object to discharge potential static.
•
Wear an approved grounding wriststrap.
•
Do not touch connectors or pins on component boards.
•
Do not touch circuit components inside the equipment.
•
If available, use a static-safe workstation.
•
When not in use, store the equipment in appropriate
static-safe packaging.
31203a-M