Rockwell Automation 1751-SLBP SynchLink Bypass Switch Block Installation Instructions - Manual (Page 9)

SynchLink Bypass Switch Block 9
Publication 1751-IN003B-EN-P - September 2001
4. Screw the removable connector to the switch block with the left and right
mounting screws.
Indicators
Figure 2 identifies the status indicators on the switch block.
Figure 2 - Status indicators
IMPORTANT
Make sure the switch block is attached and secured
prior to applying power to the switch block. Failure to
do so may cause damage to the switch block.
31224-M
POWER ON
RxIN2
TxOUT2
TxOUT
RxIN1
BYPASS ON