Rockwell Automation 1751-SLBP SynchLink Bypass Switch Block Installation Instructions - Manual (Page 7)

SynchLink Bypass Switch Block 7
Publication 1751-IN003B-EN-P - September 2001
4. Use a screwdriver to move the locking tab down while you press the switch
block flush onto the DIN rail. Release the locking tab to lock the switch
block into place. If necessary, push up on the locking tab to lock the switch
block into place.
5. Use DIN rail end anchors to secure the switch block. (Allen-Bradley catalog
number 1492-EAH35)
6. Connect the switch wiring as shown in Wiring the Bypass Switch Block
Block.
ATTENTION
!
Be certain that you secure the bypass switch block with
DIN rail anchors. Failure to do so may result in loss of
communication and/or damage to switch block.
IMPORTANT
If you exceed the switch block’s power limit, you may
cause damage to the bypass switch block.