Rockwell Automation 1794-IF8IH FLEX I/O 8 Isolated Input HART Analog Module Installation Instructions - Manual (Page 15)

FLEX I/O Isolated Input HART Analog Module 15
Publication 1794-IN115C-EN-P - April 2009
29…
32 Words 9…12 for channel 5
33…
36 Words 9…12 for channel 6
37…
40 Words 9…12 for channel 7
41 Reserved C
7 C
6 C
5 C
4 C
3 C
2 C
1 C
0
Note: Reserved data may not be shown in certain controller software
(1)
not shown or used in RSLogix 5000.
Configuration Map descriptions
BOA
BOB
Byte order group A
Byte order group B
Byte order group A and B values must
match each other.
Refer to the Byte Order table
FLTRn Channel n Digital Filter Refer to Channel Digital Filter table
Fn Fault mode channel n 0: Local/Remote
faults disabled 1: Enabled
CHn HART
Current Ratio HART current fault ratio limit
on channel n Valid values are 0, or 5…31 percent of
full scale. A value of 0 disables this
feature. Refer to the HART Current
Ratio table for more information.
DHn Disable HART
communications on channel n 0: HART
communications
enabled 1: HART
communications
disabled
Configuration Map
Word Bit
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0