Rockwell Automation 1764-xxxx MICROLOGIX 1500 PROGRAMMABLE CONTROLLERS - Manual (Page 43)

Publication 1764-UM001B-EN-P - April 2002
Installing Your Controller 2-17
Installing Controller
Components Prevent Electrostatic Discharge
Processor
ATTENTION
!
Electrostatic discharge can damage integrated circuits
or semiconductors if you touch bus connector pins.
Follow these guidelines when you handle any
module:
•
Touch a grounded object to discharge static
potential.
•
Wear an approved wrist-strap grounding device.
•
Do not touch the bus connector or connector
pins.
•
Do not touch circuit components inside the
module.
•
If available, use a static-safe work station.
When not in use, keep the module in its static-shield
bag.
ATTENTION
!
Be sure the base unit is free of all metal fragments
before removing protective debris strips and
installing the processor unit. Failure to remove strips
before operating can cause overheating.