Rockwell Automation 1785-L20C_L40C, D17856.5.14 ControlNet PLC-5 Programmable Controllers User Manual - Manual (Page 24)

Chapter 1
Installing Your ControlNet PLCĆ5 Processor
1-16
You can connect a programming terminal to a ControlNet PLC-5
processor via a:
DH+ connection
serial channel
ControlNet connection
DH+ Connection
To attach a programming terminal to a ControlNet PLCĆ5 processor using a DH+ connection:
If you use this card
to access a DH+ link: Use cable:
1784ĆPCMK G 1784ĆPCM6
G 1784ĆPCM5 with a 1784ĆCP7 adapter
1784ĆKT, ĆKT2 G 1784ĆCP6
G 1784ĆCP6 with a 1784ĆCP7 adapter
G 1784ĆCP8 adapter
1784ĆKTx, ĆKTxD 1784ĆCP13
Programming Terminal
PLCĆ5/40C
Processor
BATT
CH 0
DH+ Link
Programming Terminal
PLCĆ5/20C
Processor DH+ Link
Serial Channel
Programming Terminal
To program the processor using Channel 0, configure the channel for RSĆ232C using DF1
pointĆtoĆpoint protocol.
PLCĆ5/40C
Processor
BATT
CH 0
PLCĆ5/20C
Processor
Programming Terminal
If your programming
terminal has a: Use cable:
9Ćpin serial port 1784ĆCP10
25Ćpin serial port 1784ĆCP11
Connecting a
Programming Terminal