Rockwell Automation 1785-L20C_L40C, D17856.5.14 ControlNet PLC-5 Programmable Controllers User Manual - Manual (Page 43)

Chapter 2
Planning to Use Your ControlNet
PLCĆ5 Processor
2-15
When you download archived files to a PLC-5/20C or -5/40C processor,
the 6200 PLC-5 Programming Software ignores Channel 2 configuration
information from anything other than a ControlNet-processor program
because Channel 2 is reserved for ControlNet communication on the
PLC-5/20C and -5/40C processors. The software sets Channel 2 to the
ControlNet default configuration.
Program files ①
for this process: Archived from a: On channel:
Can be run on a
PLCĆ5/20C or
Ć5/40C channel: If they fit and are:
• PLCĆ5/11
• PLCĆ5/20
• PLCĆ5/20C
• PLC 5/20E
• PLCĆ5/40E
• PLCĆ5/40L
• PLCĆ5/60
• PLC 5/60L
0 0
• PLCĆ5/20E
• PLCĆ5/30
• PLCĆ5/40
• PLCĆ5/40C
• PLCĆ5/60L
• PLCĆ5/80
• PLCĆ5/80E 1A
1A
do nloaded nchanged
• PLCĆ5/20
• PLCĆ5/20C
• PLCĆ5/20E
• PLCĆ5/30
• PLCĆ5/40
• PLCĆ5/40C
• PLCĆ5/40E
• PLCĆ5/40L
• PLCĆ5/60
• PLCĆ5/60L
• PLCĆ5/80
• PLCĆ5/80E
1B 1B
downloaded unchanged
• PLCĆ5/20C • PLCĆ5/40C 2 2
Messaging and I/O
• PLCĆ5/11
• PLCĆ5/20
• PLCĆ5/20C
• PLCĆ5/20E
• PLCĆ5/30
• PLCĆ5/40
• PLCĆ5/40C
• PLCĆ5/40E
• PLCĆ5/40L
• PLCĆ5/60
• PLCĆ5/60L
• PLCĆ5/80
• PLCĆ5/80E
1A 2
performed by the ControlNet networkĊyou must make
• PLCĆ5/20
• PLCĆ5/20C
• PLCĆ5/20E
• PLCĆ5/30
• PLCĆ5/40
• PLCĆ5/40C
• PLCĆ5/40E
• PLCĆ5/40L
• PLCĆ5/60
• PLCĆ5/60L
• PLCĆ5/80
• PLCĆ5/80E
1B 2
performed by the ControlNet networkĊyou must make
these changes manually by reprogramming ②③④
2
• PLCĆ5/40 • PLCĆ5/80
2
• PLCĆ5/40
• PLCĆ5/60
• PLCĆ5/80
2A or 2B
1A or 1B
performed by DH+ or remote I/OĊyou must make
• PLCĆ5/60 1A or 1B
performed by DH+ or remote I/O you must make
these changes manually by reprogramming ⑤
Converting from a NonĆ
ControlNet Remote I/O
System to a ControlNet
I/O System