Rockwell Automation 1785-L20C_L40C, D17856.5.14 ControlNet PLC-5 Programmable Controllers User Manual - Manual (Page 55)

Chapter 3
Configuring Your ControlNet System
3-11
Do this: If you want to:
change a module's idle action
Ċi.e., the action that it takes
when it becomes idle
1. Move the cursor to the module's
Idle Action
field
2. Press
[F10]—Toggle Entry
to toggle between:
•
Reset
Ċto change all outputs to zero
•
Hold Last
Ċto maintain all current output values
•
Safe
Ċto change all outputs to userĆspecified fail-safe values
change a module's fault action
from idleĊi.e., the action that
it takes when it faults from idle
1. Move the cursor to the module's
Fault Action From Idle
field
2. Press
[F10]—Toggle Entry
to toggle between:
•
Idle
Ċto use the idle action
•
Fault
Ċto use the fault action
apply pending edits and return
to the ControlNet I/O Mapping
(Edit) screen
Press
[F1]—Accept Edits
go back to the ControlNet I/O
Mapping (Edit) screen
Press
[F2]—Map Edit
or
[Esc]