Rockwell Automation 1768-M04SE CompactLogix SERCOS interface Module Installation Instructions - Manual (Page 12)

12
Publication 1768-IN005A-EN-P - December 2005
Install Your Modules
Do not use both screws and DIN rail to mount the
modules. It is possible to break the mounting tabs off if
you screw the modules to the panel while they are on
DIN rail.
If You Are Using Screws to Mount Your Modules
The steps in these instructions show how to mount the modules on
DIN rail. If you are using screws instead of DIN rail, make these
changes to the instructions:
1. Follow the steps in Mount the Modules on the DIN Rail to
connect the modules together.
2. Use the modules as a template and mark pilot holes on your
panel.
3. Drill the pilot holes for M4 or #8 screws.
4. Use M4 or #8 screws to mount the modules to your panel.
Install the DIN Rail
IMPORTANT