Rockwell Automation 1788-EN2PAR Redundant EtherNet/IP to PROFIBUS PA Linking Device Quick Start - Manual (Page 2)

2 Redundant EtherNet/IP to PROFIBUS PA Linking Device
Installation Requirements
The following software and hardware tools are required to successfully install and configure the
1788-EN2PAR linking device.
Software Requirements
The following software is needed to operate the 1788-EN2PAR linking device:
• The RSLogix™ 5000 Add-on Profile AOP is required to configure and perform
diagnostics on the 1788-EN2PAR linking device.
• The Device Type Manager (catalog number 1788-EN2PAR DTM) is required for
Asset Management connectivity with field devices.
Hardware Requirements
The following hardware is required to install and configure the 1788-EN2PAR linking device:
• A 24…32V DC power supply.
• An EtherNet/IP connection via a RJ-45 connector.