Rockwell Automation 1766-L32xxx MicroLogix 1400 Programmable Controllers Web Server User Manual - Manual (Page 6)

Publication 1766-UM002A-EN-P - November 2008
4 MicroLogix 1400 Embedded Web Server
Connect the MicroLogix
1400 controller to the
Network
1. Connect the module to
the network.
Connect the MicroLogix 1400 controller to the Ethernet network. The
RJ-45 connector is on the left-hand side of the module.
2. Obtain an IP address. By default, the MicroLogix 1400 controller is BOOTP enabled. If you
connect the MicroLogix 1400 controller to a network that has a
BOOTP server, that server will assign an IP address to the MicroLogix
1400 controller and the LCD screen of the MicroLogix 1400 controller
will display BOOTP IP address.
If your network does not have a BOOTP server, use one of the
methods described in the MicroLogix 1400 Programmable Controllers
User Manual
1766-UM001 to assign an IP address to the MicroLogix
1400 controller.
44592
For more information, see
MicroLogix1400 Programmable
Controllers User Manual
1766-UM001 .