Rockwell Automation F1770-KFC(D)15 INSTL INSTR FLASH FIRMWARE KIT - Manual (Page 3)

Flash Firmware Kit 3
Publication 1770-5.9 - May 1998
1. Carefully remove the cover by removing the four screws on the
bottom of the module.
2. Enable the boot section by installing the jumper onto the Boot
Block Enable header. The Boot Block Enable header is located on
the main printed circuit board inside the module as shown below.
Now that the jumper is installed, you will not need to remove it
during the life of the module.
3. Replace the cover and four screws.
4. Connect the module to either available COM port of your
computer.
Important: Do not connect the module to the ControlNet
network. (Do not make connections to BNC or NAP
ports).
5. Connect the AC or DC power cord and apply power.
Next you will reset the module parameters.
30582-M
Inside of Module
Jumper
Boot Block Enable header