Rockwell Automation F1770-KFC(D)15 INSTL INSTR FLASH FIRMWARE KIT - Manual (Page 6)

6 Flash Firmware Kit
Publication 1770-5.9 - May 1998
You see this screen:
Look at the front of the module. The HOST LED blinks green
and the STATUS LED blinks red during the download.
When the download is complete, you see the following message:
Code Download into KFC Flash Memory Succeeded
If you see the message:
NVS transfer failure. Download aborted
go to the troubleshooting section on page 9.
If the upgrade:
• progressed as outlined in this section, go to the section “Place
the Label” on page 8 to continue with the upgrade.
•did not progress as outlined in this section, go to the
troubleshooting section on page 9.
Upgrade the 1770-KFCD Firmware Important: You cannot upgrade 1770-KFCD firmware using
1770-KFC binary files. Mixing binary files between
firmware can make the product inoperable.
To upgrade the 1770-KFCD:
1. Flash the main code by entering the following information at the
DOS prompt:
DLOAD KFCD15.BIN COM1 38
•COM1 indicates which serial port you are using
•38 indicates a 38.4K baud rate
Change these settings, if necessary, based on your computer’s
serial port and baud rate.
KFC flash memory download utility - Version 0.8
Copyright 1994 by the Allen-Bradley Company
---------Downloading binary image to KFC (MacId#) flash memory