Rockwell Automation 1790D-XXXX DeviceNet Digital Base Terminal Block CompactBlock LDX I/O Series B - Manual (Page 8)

8 DeviceNet Digital Base Terminal Block CompactBlock LDX I/O
Publication 1790-IN012B-EN-P - July 2008
Mount on a Panel
For panel mounting, use these steps.
1. Place the block against the panel where you want it mounted.
2. Gently pull and position the expansion cover to the left.
3. Place a center punch, nail, or similar device through the
mounting holes in the block and make two marks on the
panel at the lower-left and upper-right corners of the module.
4. Remove the block and drill two holes in the panel to
accommodate each of the mounting screws.
5. Replace the block on the panel and place a screw through
each of the two mounting holes.
6. Tighten the screws until the block is firmly in place.
Mount on DIN Rail
For DIN-rail mounting, use these steps.
1. Hook the top slot of the base block over the DIN rail.
2. Pull down on the locking lever while pressing the base block
against the rail.
44610
Locking Lever