Rockwell Automation 1746-XXXX SLC 500 4-Channel Analog I/O Modules User Manual - Manual (Page 34)

Publication 1746-UM005B-EN-P - June 2004
3-12 Installing and Wiring Your Analog Module
Labeling and Installing the
Terminal Block The terminal block has a write-on label. Labeling the terminal block
will help ensure that it is installed on the correct module.
Once you have wired your analog module and properly labeled the
terminal block, install the terminal block on the analog module. To
install the terminal block:
1. Align the terminal block with the receptacle.
2. Insert the terminal block and press firmly at the top and bottom
until it is properly secured.
Grounding the Foil Shields
and Drain Wires You are now ready to earth ground your foil shield and drain wire
from each cable. Do not connect the foil shield or drain wire to the
analog module terminal block. The foil shield and drain wire must be
connected to earth ground, which is not available on the terminal
block. Refer to the illustration on the next page for wiring diagrams of
the analog modules.
SLOT ____ RACK ____
MODULE _____
Note: The black dot on the terminal block
label indicates the position of terminal 0.