Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 58)

7-4 Processor Control Functions
Publication 1747-6.1
Transferring Memory
from EEPROM to RAM
You may transfer a program between processor EEPROM and RAM
memory.
To transfer EEPROM to RAM, from any display:
1. Configure the module for the Modify mode.
2. Make sure the processor is in the Program mode.
3. To initiate the memory transfer:
Press >) @ >6+,)7@ >5@
4. The module displays:
5. To confirm:
Press >(17(5@
To abort the memory transfer:
Press
>(6&@ The display returns to the previous Ready
Attached screen.
6. When the transfer is initiated, the module displays:
7. If the memory transfer is successful, the module displays:
If the program contained in the EEPROM is password-protected,
you are required to re-enter the password at this point.
8. When the transfer is complete (or the password is entered, if
required), the module displays the Ready Attached screen:
If an error occurs during the transfer, an error message displays on the
bottom line of the display. Refer to chapter 9, Troubleshooting.
Confirm?
PROM -> CPU RAM,
Working . . . .
PROM -> CPU RAM,
Transfer Success
PROM -> CPU RAM,
RDY> 4 RHALT
5/02 1111