Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 59)

Processor Control Functions 7-5
Publication 1747-6.1
Transferring Memory
from RAM to EEPROM
To transfer a program from processor RAM to EEPROM memory,
from any display:
1. Configure the module for the Modify mode.
2. Make sure the processor is in the Program mode.
3. To initiate the memory transfer:
Press >) @ >6+,)7@ >1@
4. The module displays:
5. To confirm:
Press >(17(5@
If the >(6&@ key is pressed at the Confirm screen, the display
returns to the previous Ready Attached screen, and the memory
transfer is aborted.
6. When the transfer is initiated, the module displays:
7. If the memory transfer is successful, the module displays:
8. When the transfer is complete, the module returns to the Ready
Attached screen.
If an error occurs during the transfer, an error message displays on the
bottom line of the display. Refer to chapter 9, Troubleshooting.
Confirm?
CPU RAM -> PROM,
Working . . . .
CPU RAM -> PROM,
Transfer Success
CPU RAM -> PROM,