Rockwell Automation 1786-TPST2T ControlNet IP67 Tap and Cable Assembly Kit Installation Instructions - Manual (Page 10)

10 ControlNet IP67 Tap and Cable Assembly Kit Installation Instructions
Publication 1786-IN017B-EN-P - May 2004
1. If your installation requires IP67-rated connectors, slide the heat-shrink tubing onto
the cable.
2. Place the crimp ferrule on to the cable.
3. Strip the cable using the 1786-CTK stripper tool.
4. Trim the center conductor to the required length as directed on the connector bag.
5. Push the flare tool onto the cable with a slight twisting motion (with sufficient inward
pressure to expand the braid).
6. Place the center pin over the center conductor.
IMPORTANT
Be certain that the center pin slips onto the center conductor completely.
The back shoulder of the center pin should be up against the white
insulation. If it is not, recheck the length of the center conductor.
41888
41890
Push the flare/calibration tool gently and rotate
slightly onto the connector while applying pressure.
This will work the base of the connector underneath
the wire braid slowly.