Rockwell Automation 1756-EN2TXT ControlLogix-XT EtherNet/IP Bridge Module - Manual (Page 11)

ControlLogix-XT EtherNet/IP Bridge Module 11
Publication 1756-IN635A-EN-P - March 2009
Reset the Module to Initial Settings
To reset the module to its initial out-of-the-box settings, reset the
switches to 888 and cycle power.
After cycling power with the switches set to 888, remove the module
and set the switches to their final value. When you set the rotary
switches to a value other than 888, or to the valid IP address values
001…254, the software configuration determines the IP address.
IMPORTANT Do not use the 888 switch setting during normal module operation.