Rockwell Automation 1756-EN2TXT ControlLogix-XT EtherNet/IP Bridge Module - Manual (Page 17)

ControlLogix-XT EtherNet/IP Bridge Module 17
Publication 1756-IN635A-EN-P - March 2009
Remove the Module
You can remove and re-install this module while chassis power is
applied. Complete these steps to remove the module.
1. Push on upper and lower module tabs to disengage them.
2. Slide the module out of the chassis.
WARNING
When you insert or remove the module while backplane power is on, an
electrical arc can occur. This could cause an explosion in hazardous
location installations.
Be sure that power is removed or the area is nonhazardous before
proceeding. Repeated electrical arcing causes excessive wear to
contacts on both the module and its mating connector. Worn contacts
may create electrical resistance that can affect module operation.
IMPORTANT
If you want to replace an existing module with an identical one, and you
want to resume identical system operation, you must install the new module
in the same slot.
X
T
LINK NET OK
10/100/BASE T
X
T