Rockwell Automation 1792D-8BT0LP ArmorBlock LP2 8 Sinking Input Module - Manual (Page 3)

ArmorBlock LP2 8 Sinking Input Module 3
Publication 1792D-5.47 - August 1999
Install Your ArmorBlock LP2 I/O Module
To install the module:
• Set the node address and baud rate.
• Mount the module.
• Connect the input cord sets to the LP2 module
• Communicate with your ArmorBlock LP2 module.
More detailed information about each of these steps is in the following
procedures.
Set the Node Address
Set the node address using RSNetWorx for DeviceNet
™ software,
DeviceNetManager
™ software, or another software configuration tool. The
module is equipped with AutoBaud detect. AutoBaud lets the module read
the settings already in use on your DeviceNet network and automatically
adjusts to follow those settings.
Mount the Module
1. Mount the module using the dimensions shown below.
2. Connect the grey DeviceNet cable to the DeviceNet trunk. Use the
1485P-P1R5-MN5R1 T-Part tap to make the connection to round
media. Use the 1485P-P1E4-R5 to connect to the Kwik Link flat media
system.
I-0
I-1
I-2
I-3
I-7
I-6
I-5
I-4
Network Status Module Status
4.21in
107mm
0.25in
6.25mm
12in
305mm
1.95in
49.5mm
42041
4.72in
120mm
2.7in
68.5mm
(width)