Rockwell Automation 2706-LV2S_LV4S DL40 PLUS SLAVE USER MANUAL - Manual (Page 30)

Publication 2706-6.3
Installation and Startup 3-13
Startup Sequence
When power is applied to the DL40 Plus Slave a powerup sequence
of displays are shown. The first display on powerup is the sign-on
banner identifying the hardware and firmware:
Following the sign-on banner, all of the display pixels are turned on
for 2 seconds followed by a series of informational messages
indicating the current DIP switch settings. Each display lasts for
about four seconds.
After the status messages are displayed, the DL40 Plus Slave clears
the display and enters the selected run mode.
DL40 PLUS SLAVE 2L
VER 1.00 (10/16/98)
DL SLAVE MODE
ENGLISH TEXT
DL SLAVE MODE
PV SLAVE MODE
TERMINAL MODE
DIAGNOSTIC MODE
ENGLISH
INTERNATIONAL TEXT
CYRILLIC TEXT
ENGLISH TEXT (2)
SERIAL ADDRESS: XXX
0 to 127
19200 BAUD (N-8-1)
19200
9600
1200
300
Parity / Data Bits / Stop Bits
N - 8 - 1
E - 7 - 1
O - 7 - 1
CURSOR ENABLED
AUTO LINE ENABLED
CURSOR ENABLED
CURSOR DISABLED
AUTO LINE ENABLED
AUTO LINE DISABLED