Rockwell Automation 57C403 115VAC High Power Output Module - Manual (Page 7)

1Ć1
1.0 INTRODUCTION
The products described in this instruction manual are manufactured
or distributed by Reliance Electric Company or its subsidiaries.
This 115 VAC High Power Output Module will drive a maximum of
sixteen 115 volt control signals as outputs from the DCS
5000/AutoMax system. The output signal frequency may be either 50
or 60 hertz. Individual outputs are rated at a maximum current of 2
amps. Outputs have high inrush capacity for handling capacitive
loads. Output signals have 2500 volt isolation to logic common. The
module contains four isolated commons, each having four outputs.
Typically, this module is used to output on/off signals to devices such
as solenoids or motor starters that may need up to 2 amps current or
have a large inrush current requirement.
This manual describes the functions and specifications of the
module. It also includes a detailed overview of installation and
servicing procedures, as well as examples of programming
methods.
Related publications that may be of interest:
D JĆ3630 ReSource AutoMax PROGRAMMING
EXECUTIVE INSTRUCTION MANUAL VERSION 1.0
D JĆ3649 AutoMax CONFIGURATION TASK MANUAL
D JĆ3650 AutoMax PROCESSOR MODULE
INSTRUCTION MANUAL
D JĆ3675 AutoMax ENHANCED BASIC LANGUAGE
INSTRUCTION MANUAL
D JĆ3676 AutoMax CONTROL BLOCK LANGUAGE
INSTRUCTION MANUAL
D JĆ3677 AutoMax LADDER LOGIC LANGUAGE
INSTRUCTION MANUAL
D JĆ3684 ReSource AutoMax PROGRAMMING
EXECUTIVE INSTRUCTION MANUAL VERSION 2.0
D JĆ3750 ReSource AutoMax PROGRAMMING
EXECUTIVE INSTRUCTION MANUAL VERSION 3.0
D IEEE 518 GUIDE FOR THE INSTALLATION OF ELECTRICAL
EQUIPMENT TO MINIMIZE ELECTRICAL NOISE INPUTS TO
CONTROLLERS FROM EXTERNAL SOURCES