Rockwell Automation 2711C-xxxx PanelView Component HMI Terminals Quick Start - Manual (Page 12)

12 Publication 2711C-QS001F-EN-P - November 2010
Required Software
To complete this quick start, the following software is required:
• PanelView Explorer software, V1.0 or higher
This software is resident on your PanelView Component terminal.
Separate software is not required. After establishing an Ethernet
connection between your terminal and computer, you can launch the
PanelView Explorer software from your web browser by entering the IP
address of the terminal.
• Computer with Windows XP, Vista, or 2000 operating
system and a web browser
The browser is needed to launch the PanelView Explorer software while
connected to a PanelView Component terminal.
• PanelView USB RNDIS Device driver
This driver must be installed on your computer if you intend to connect
your computer to the terminal using the USB port on the terminal. You
can install the driver on a computer with the Windows XP or Vista
operating system, not Windows 2000.
Operating System Web Browser
Windows Vista Firefox 2.0 or 3.0
Internet Explorer 7 or 8
Windows XP SP2 Firefox 2.0 or 3.0
Internet Explorer 7 or 8
(1)
(1) Internet Explorer 6 is supported but not recommended. For optimal
performance, use Internet Explorer 7 or 8, or Mozilla Firefox 2.0 or 3.0.
Windows 2000 SP4 or later
(Ethernet only)
Firefox 2.0 or 3.0
Internet Explorer 7 or 8
(1)