Connect power to terminal, Connect power, To terminal – Rockwell Automation 2711C-xxxx PanelView Component HMI Terminals Quick Start User Manual
Page 24
Advertising
24
Publication 2711C-QS001F-EN-P - November 2010
Chapter 2 Make Terminal Connections
Connect Power to Terminal
1.
Optionally, remove the
terminal block from the
terminal for ease of wiring.
2.
Insert the DC+, DC-, and
the functional-earth ground
wires and tighten terminal
screws.
3.
Re-attach terminal block to
terminal.
4.
Plug the 3-prong power
connector into a 24V DC
power source.
For power requirements of
the PanelView Component
terminal, refer to the
installation instructions,
The terminal goes through a
series of self-tests and then
displays the configuration
application for the terminal.
DC+
DC-
Functional
Earth Ground
to Ground Bus
Advertising