Rockwell Automation 4100-ESRS ESRS - Encoder Signal Reference Simulator Manual - Manual (Page 25)

Publication 4100-IN505A-EN-P - October 2000
Installation 2-7
recommended minimum current capacity for the external power
supply is 1 Amp.
This diagram shows how to connect the ESRS to a power supply
adjacent to the ESRS.
Figure 2.6 External Power Supply Adjacent to Encoder
ATTENTION
!
The ESRS does not contain reverse supply polarity
protection. You must observe polarity when
installing the unit. Reverse supply polarity can
permanently damage the ESRS.
P2
PIN 6
PIN 9
+
_
External
5V DC Supply
Link PINS
9 and 14