Rockwell Automation 4100-ESRS ESRS - Encoder Signal Reference Simulator Manual - Manual (Page 32)

Publication 4100-IN505A-EN-P - October 2000
3-6 Operation
P2
The P2 connector is a 15 way male high density D connector. It allows
you to make connection to the quadrature pulse train and index plus
power (+5 and +12V DC).
The following table shows the Pin Number and the matching Signal
name.
The A+ and A-, B+ and B-, I+ and I- outputs are RS422 TTL level
outputs. These outputs are intended to be connected to bi-directional
line receivers in the target equipment. If single ended outputs are
required A+, B+, and I+ outputs can be used and A-, B-, and I- are left
unconnected.
Options Switch The Options Switch is a 10 lever DIP switch mounted on the printed
circuit board (PCB). Use this switch to set the various configurations
options. With the box mounted vertically, the switch is positioned on
the horizontal. Each of the 10 levers is numbered from left to right
with 1 being to the extreme left and 10 being to the extreme right. A
switch is in the ON position when the upper portion of the lever is
depressed. It is in the OFF position when the lower portion of the
lever is depressed.
Table 3.C P2 Pin Functions
Pin Number Signal Name
1 A+
2 A-
3 B+
4 B-
5 I+ (Z+)
6 Common
7 Common
8 +12V DC
9 +5V DC
10 I- (Z-)
11 Not Used
12 Not Used
13 Not Used
14 +5V DC
15 Shield