Rockwell Automation 2711P-RY2032 Battery Replacement Installation Instructions - Manual (Page 3)

Battery Replacement 3
Rockwell Automation Rockwell Automation Publication 2711P-IN009F-EN-P - July 2014
Precautions
Perchlorate material – special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate .
This perchlorate warning only applies to primary Lithium Manganese Dioxide (LiMnO
2
) cells
or batteries, and products containing these cells or batteries, sold or distributed in California,
USA.
Replace Battery in PanelView Plus Terminals
Follow these steps to replace the battery in the logic module of any PanelView Plus terminal with
a 700 to 1500 display.
1. Disconnect power from the terminal.
2. Disconnect all power and communication cables.
These products contain a sealed lithium battery which may need to be replaced during the life of the product.
At the end of its life, the battery contained in this product should be collected separately from any unsorted
municipal waste.
The collection and recycling of batteries helps protect the environment and contributes to the conservation of
natural resources as valuable materials are recovered.
WARNING: There is a danger of explosion if the lithium battery or real-time clock module in this product is
incorrectly placed. Replace the battery only with the indicated type. Do not replace the battery or real-time clock
module unless power has been removed or the area is known to be nonhazardous.
Do not dispose of the lithium battery or real-time clock module in a fire or incinerator. Dispose of the battery in
accordance with the local regulations. For safety information on the handling of lithium batteries. including
handling and disposing of leaking batteries, see Guidelines for Handling Lithium Batteries, publication
AG-5.4 .
WARNING: The battery or real-time clock module in these products must only be changed in an area known to be
nonhazardous.
ATTENTION: Work in a static-free environment and wear a properly grounded electrostatic discharge (ESD)
wristband.
Be careful when touching any of the exposed electronic components to prevent damage from ESD.