Rockwell Automation 2711P-RY2032 Battery Replacement Installation Instructions - Manual (Page 8)

8 Battery Replacement
Rockwell Automation Rockwell Automation Publication 2711P-IN009F-EN-P - July 2014
11. Push down on the logic module until it is firmly seated.
12. Tighten the four captive screws that secure the logic module to a torque of 0.58 N•m
(5…7 lb•in).
13. Reattach the communication module, if necessary, and tighten the four screws to a
torque of 0.58 N•m (5…7 lb•in).
Replace Battery in PanelView Plus 7 Standard Terminals
Follow these steps to replace the battery in PanelView Plus 7 Standard 400 to 1000 terminals.
1. Disconnect power from the terminal.
2. Remove the battery cover by rotating it from the C(lose) to O(pen) position.
3. To disengage the battery, on the metal latch, press the vertical center tab away from the
battery.
The battery is released.