Rockwell Automation 6180P-xxxx Integrated Display Computers with Keypad Installation Instructions - Manual (Page 12)

12 Industrial Integrated Display Computers with Keypad
Rockwell Automation Publication 6180P-IN001C-EN-P - July 2013
To connect DC power, follow these steps.
1. Secure the DC power wires to the terminal block screws.
2. Secure the ground wire to the GND terminal block screw.
3. Apply 24V DC power to the computer.
Functional Ground Screw
The use of the functional ground screw is not
required for safety and regulatory compliance.
However, if a supplemental ground is desired,
use the functional ground screw on the side
panel of the computer.
Side View